Back in Winning Blue. Our 'new' Project Blue!
-
- Posts: 18
- Joined: Sat Feb 09, 2013 7:32 pm
Re: Back in Winning Blue. Our 'new' Project Blue!
Sounds like winning blue is working out very well. What is the measurement between the fender lip and the center of the wheel f/r?
Re: Back in Winning Blue. Our 'new' Project Blue!
We set front height at 13.25 and rear at 13.5
Front Camber -1.5
Toe Out 1/32 per side
Caster 6.5
Rear Camber -1.7
Toe ZERO
Front Camber -1.5
Toe Out 1/32 per side
Caster 6.5
Rear Camber -1.7
Toe ZERO
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Good-Win Racing
www.good-win-racing.com
Re: Back in Winning Blue. Our 'new' Project Blue!
What will be required to fit these brakes to RPF1 17 x 10s x 38?
Thanks. Rick
Thanks. Rick
Re: Back in Winning Blue. Our 'new' Project Blue!
Those will easily bolt up and clear with no spacers.ourly wrote:What will be required to fit these brakes to RPF1 17 x 10s x 38?
Thanks. Rick
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Good-Win Racing
www.good-win-racing.com
Re: Back in Winning Blue. Our 'new' Project Blue!
The joys of being a Project car here is always getting taken apart for something!
Today Project Blue is trying new version of our QuickChange Roll Bar with rear supports that you add just for track days. As you can see, new version uses much simplified connection at the top. The change is needed because the old version was actually TOO PRECISE for the car. As these cars age they get a little middle age spread in the open chassis, much like lots of people we know. As a consequence, rear braces often fit a new car but not a car with more miles that had 'relaxed' too much. The geometry of this new design is a little more simple and fits easier to a variety of NC ages.
This is the finished rough, which will be used to finish the JIG, and this one goes to powder coating on Monday morning and then to the customer who has waited patiently for months while we did this re-engineering (thanks for waiting!).
Today Project Blue is trying new version of our QuickChange Roll Bar with rear supports that you add just for track days. As you can see, new version uses much simplified connection at the top. The change is needed because the old version was actually TOO PRECISE for the car. As these cars age they get a little middle age spread in the open chassis, much like lots of people we know. As a consequence, rear braces often fit a new car but not a car with more miles that had 'relaxed' too much. The geometry of this new design is a little more simple and fits easier to a variety of NC ages.
This is the finished rough, which will be used to finish the JIG, and this one goes to powder coating on Monday morning and then to the customer who has waited patiently for months while we did this re-engineering (thanks for waiting!).
- Attachments
-
- QuickChange-NC-MX5-ROLL-BAR.jpg (127.39 KiB) Viewed 11018 times
-
- Quickchange-NC-ROLL-BAR.jpg (175.12 KiB) Viewed 11018 times
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Good-Win Racing
www.good-win-racing.com
Re: Back in Winning Blue. Our 'new' Project Blue!
Looks great Brian. Will you be stocking these? Also, when will they be available?
Thanks!
Thanks!
06 GT GG, PSS10, Hotchkis, GWR exhaust, RPF1, AD08, IL braces, MS, dptune
91 A CR 5sp, Millen, FM, GAB, MOMO, Panasport, Naca, braced
91 A CR 5sp, Millen, FM, GAB, MOMO, Panasport, Naca, braced
Re: Back in Winning Blue. Our 'new' Project Blue!
Figure about 7 days until we have more to ship.
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Good-Win Racing
www.good-win-racing.com
Re: Back in Winning Blue. Our 'new' Project Blue!
NEXT MOD!
After much waiting and anticipation.....the NEW Tomei NC Limited Slip is HERE!
The good folks from Tomei, a premier tuning company in Japan, visited us back in September. As reported at that time in the Tomei thread, their new 12 disc limited slip was perhaps the most exciting item we discussed at that time and now it is here! Hope to have it installed in time to autocross it this weekend.
After much waiting and anticipation.....the NEW Tomei NC Limited Slip is HERE!
The good folks from Tomei, a premier tuning company in Japan, visited us back in September. As reported at that time in the Tomei thread, their new 12 disc limited slip was perhaps the most exciting item we discussed at that time and now it is here! Hope to have it installed in time to autocross it this weekend.
- Attachments
-
- FactoryPumpkin.jpg (93.14 KiB) Viewed 10650 times
-
- Tomei-LSD.JPG (129.71 KiB) Viewed 10729 times
-
- Tomei-Limited-Slip.JPG (139.45 KiB) Viewed 10729 times
-
- Tomei-MX5-NC-Limited-Slip.JPG (141.38 KiB) Viewed 10729 times
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Good-Win Racing
www.good-win-racing.com
Re: Back in Winning Blue. Our 'new' Project Blue!
I'm certainly interested.
Re: Back in Winning Blue. Our 'new' Project Blue!
Awesome fun Autocross Day with the new Tomei Limited Slip!
The new Tomei "Traxx" Limited Slip did the job with no drama, no matter how much I flung the car about it drove out of the tightest turns smoothly.... very confidence inspiring to drive the car from the corners and through fast transitions.
The new Tomei "Traxx" Limited Slip did the job with no drama, no matter how much I flung the car about it drove out of the tightest turns smoothly.... very confidence inspiring to drive the car from the corners and through fast transitions.
- Attachments
-
- TOMEI-LIMITED-SLIP-TEST-DAY.JPG (132.83 KiB) Viewed 10600 times
-
- Tomei-Limited-Slip-Test.JPG (117.83 KiB) Viewed 10600 times
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Good-Win Racing
www.good-win-racing.com