Page 1 of 1

Racing Beat bars & end links

Posted: Sat Jun 22, 2013 9:45 pm
by TimW536
Got the Racing Beat ARBs and end links installed today, heading onto the scales tomorrow (also finished coilover install). Was expecting the end links to have RH & LH threads so as to adjust length and zero the bar at static ride height. But they were both RH threads on the stud between.

Whats the technique to ensure the ARB is not loaded at static right height? Is removing the end links to adjust really the only way?

TIA.

Tim

Re: Racing Beat bars & end links

Posted: Mon Jun 24, 2013 7:09 am
by Brian
Yes, the RB links are a bargain but part of the low cost compromise is that you do need to disconnect one end to get them set to length you want while fully unloaded.