Page 1 of 1

Installation of RB sway bars or Progress Sways

Posted: Sat Nov 23, 2013 3:35 pm
by DanielD217
I just bought an 06 MX5. Don't like the body roll so want to install better sways. As far as installation of the RB's over the progress bars I would like to know if the install is any more difficult with one over the other. Do any modifications need to be made to the car to install either one of these? I am new to this so have patience with me. Also which would be the best to install. I have my fun on very twisty mountain roads. I may try autocross at some point for fun but nothing serious.
Daniel

Re: Installation of RB sway bars or Progress Sways

Posted: Sun Nov 24, 2013 8:23 am
by Brian
Both choices are simple bolt on, no permanent changes to car. Rear is about 10 minutes. Front takes a good hour or more the first time you do it. Progress front bar might be slightly more difficult because of the bigger diameter but just slightly.

Re: Installation of RB sway bars or Progress Sways

Posted: Sun Nov 24, 2013 11:11 am
by DanielD217
Thanks for the quick response Brian.