NC2 RB sway bar set up

Miata Parts, Intakes, Superchargers, Headers, Exhausts, Shocks, Springs, Sway Bars, Brake Kits, Autocross and track mods.

NC2 RB sway bar set up

Postby JonD250 » Fri May 16, 2014 1:37 pm

My search skills are lacking, so if this is a repost, I apologize. I am installing the RB sways this weekend on the front and rear of my NC2. Will this combo decrease understeer when attached in the middle hole on the front and the hole nearest the end on the rear per the instructions? Or, since I know I want to reduce low speed understeer, should I go with the stiffer rear set up?

TIA
Jon D.
JonD250
 
Posts: 3
Joined: Sun Mar 02, 2014 7:38 pm
Location: Evans, G

Re: NC2 RB sway bar set up

Postby Brian » Sat May 17, 2014 9:17 am

I suggest starting with middle hole front and hole nearest bar ends of rear. Drive and see what you think. Other variables effect the balance like alignment settings. If still too much understeer after first few drives then set rear bar to tighter position....or front bar to loose (connection nearest bar ends)....or both as needed.
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Brian
Site Admin
 
Posts: 7875
Joined: Tue Feb 15, 2005 11:44 am
Location: San Diego CA


Return to Mazda Miata and Fiat 124

Who is online

Users browsing this forum: Bing [Bot] and 10 guests