CG-Lock in NC
Posted: Sat Jul 30, 2016 5:51 pm
Bought this CG-Lock from Good-Win to try as a step between the factory seatbelts and a full harness (where I'll probably end up eventually). Tried to install it today, but the clamping method to the seatbelt tang leaves a lot to be desired. It doesn't line up with the thickness of the plastic overmold, and the clamp cants in such a way as not not actually grip the seatbelt tang at all. Slips off at the first tug no matter how much I can screw down the tiny little clamping screws.
Sure, I can still use the cam-lock feature on the actual seat belt, but it won't stay in position on the tang.
I did but the unit intended for the NC (2006-2015) for my 2009, but it just won't grip.
Short of grinding off the plastic overmold on the seatbelt tang, any suggestions?
Best,
- Rob.
Sure, I can still use the cam-lock feature on the actual seat belt, but it won't stay in position on the tang.
I did but the unit intended for the NC (2006-2015) for my 2009, but it just won't grip.
Short of grinding off the plastic overmold on the seatbelt tang, any suggestions?
Best,
- Rob.