ND Ride Height - Roadstersport springs and KONIs

Miata Parts, Intakes, Superchargers, Headers, Exhausts, Shocks, Springs, Sway Bars, Brake Kits, Autocross and track mods.
Post Reply
BillK336
Posts: 54
Joined: Sat Oct 03, 2015 1:31 am

ND Ride Height - Roadstersport springs and KONIs

Post by BillK336 »

I installed KONIs, Roadstersport springs and bumpstops last week, jacking each corner individually. And redid the right front after approx 140 miles.
Height is as follows:

left right
front 13 3/8 14
rear 13 5/8 13 1/2

Right front was always high, even before the install. I had loosened all the non-alignment bolts in front, jacked up the lower A-arm, and retightened.
I'm thinking I should go for the alignment bolts as well.
2020 JBM Sport MT, GWR RaceTT, Conti DWS, Cobalt FSTB, Voodoo, Cravenspeed, and mx5things bits…
RIP '16 MG Club GWR, Race TT, Versatune, RS Springs & Konis, Conti ECS, TRM FF10, AA & AIO, etc...
'97's SOLD...
Brian
Site Admin
Posts: 11307
Joined: Tue Feb 15, 2005 11:44 am
Location: San Diego CA
Contact:

Re: ND Ride Height - Roadstersport springs and KONIs

Post by Brian »

Good results, it will settle out a bit with time.
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Post Reply