93 LE miata with the factory Bilsteins (125k miles) and Springs.
Ordered the 58mm Red/White AutoCross bumps. It's probably a dumb question, but would like to make sure I've got everything set before I start the install.
I'm guessing that I:
1) Pull the shock
2) put spring compressors on
3) remove the center bolt
4) Throw the dust boot (already in many pieces) / rubber bump into the trash
5) Bumps go on, the narrow end toward shock body
6) Put the center screw on
7) Install shocks.
Are there any spacers, fender washers, that should be going on top of the bumps, or am I good with just the bump stop on the shock shaft?
93Le Miata Bump Stop Upgrade
Re: 93Le Miata Bump Stop Upgrade
No extra bits needed, you swap just the low density stock stops for these higher density versions.
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Good-Win Racing
www.good-win-racing.com
Re: 93Le Miata Bump Stop Upgrade
Thanks for the Help!