Page 2 of 4
Re: Replacing NC seats with Sparco
Posted: Tue Oct 26, 2010 6:01 am
by rpmchris
No. It's in their "street" line. It's very much like their Evo but with additional scuff resistance on the sides and a bottom mount (vs. side mount).
Come to think of it, the Evo doesn't have a crotch passthru either...
Re: Replacing NC seats with Sparco
Posted: Tue Oct 26, 2010 6:33 am
by 07miata
Dang! Thanks for letting me know though. Very nice seats.
Re: Replacing NC seats with Sparco
Posted: Tue Oct 26, 2010 9:42 am
by slartibartfast
rpmchris wrote:Come to think of it, the Evo doesn't have a crotch passthru either...
Evo II does. That the seat in our LeMons Sentra SE-R.
Re: Replacing NC seats with Sparco
Posted: Sun Oct 31, 2010 7:15 am
by rpmchris
Huh...is the passthrough under the front center bolster?
Re: Replacing NC seats with Sparco
Posted: Mon Nov 01, 2010 8:26 pm
by slartibartfast
Lift the thigh padding to find the pass-thru. It's attached with Velcro (tm).
Re: Replacing NC seats with Sparco
Posted: Tue Nov 02, 2010 7:18 pm
by rpmchris
Nope. Just checked - it's not on the Fighter.
Re: Replacing NC seats with Sparco
Posted: Mon Nov 08, 2010 7:30 pm
by skeeler
Chris,
The photos on your Flickr stream are certainly helpful. Thanks. What type of material and what thickness did you use for your fabricated seatbelt-buckle mount?
Thanks again.
Re: Replacing NC seats with Sparco
Posted: Thu Nov 11, 2010 9:02 am
by rpmchris
The straps were 2" wide, 14 gauge (about 2mm).
Re: Replacing NC seats with Sparco
Posted: Tue Nov 23, 2010 5:15 pm
by skeeler
Chris,
Thanks for the information.
I noticed that the seat rails I ordered from Brian came with an extra small, loose plate. I assume, since there is just one, that it is somehow related to mounting the passenger-side seatbelt at the bottom, since, in stock form, that end of the belt attaches to the passenger seat. Is that correct, or is it intended for another purpose? Should I have received two of them?
Thanks again.
Re: Replacing NC seats with Sparco
Posted: Mon Nov 29, 2010 7:01 pm
by rpmchris
Huh...I don't remember getting one of those.