Page 1 of 1

Heavy Duty Sway Bar Mounts Install

Posted: Tue Jan 20, 2015 11:10 am
by Chameleoki
I am installing the Heavy Duty Sway Bar Mounts and they was wondering if they are supposed to be perfectly flush with the frame. I have them pushed on enough (had to use a big c-clamp to get them to that point) to screw on the bolts but there is a tiny gap in between the mount and the frame underneath. Just wondering if they are supposed to press right up to the bottom of the frame or not.

Thanks!

Re: Heavy Duty Sway Bar Mounts Install

Posted: Tue Jan 20, 2015 4:43 pm
by Brian
The uneven sitting/thickness of the powder coating will often lift up a corner or two on those but it will be fine.