Progress sway and RB end links install

Installations instructions for MonsterFlow intakes, Big Brake Kits, shocks and more.

Progress sway and RB end links install

Postby roadster_nh » Fri Feb 20, 2015 5:09 pm

I'm installing progress sways and RB end links -- wondering how important it is for the arms to be parallel to the ground. If it is important, I don't see how that's going to happen unless I'm doing something wrong. Picture below shows car on stands with only one end link connected.

Does everything here look correct?
Attachments
image.jpg
image.jpg (1.04 MiB)
image.jpg
image.jpg (1.26 MiB)
2009 - Marble White
roadster_nh
 
Posts: 46
Joined: Mon Jun 28, 2010 5:19 pm
Location: DFW

Re: Progress sway and RB end links install

Postby njaremka » Sat Feb 21, 2015 5:35 am

The way the NC bar is designed, it just isn't going to happen. Just make sure there isn't any twist in the bar when the car is sitting on the ground.
njaremka
 
Posts: 71
Joined: Fri Dec 17, 2010 10:31 am

Re: Progress sway and RB end links install

Postby morrisg » Sun Feb 22, 2015 5:43 pm

Because the end links are ball joints, there won't be any bind up if you tighten them while the suspension is in full droop and then put the car back on the ground when finished. No problems, finish up and enjoy!
morrisg
 
Posts: 122
Joined: Mon Nov 15, 2010 12:02 am


Return to Installation Instructions

Who is online

Users browsing this forum: No registered users and 1 guest