ND Headlight Level Adjuster - help needed

Installations instructions for MonsterFlow intakes, Big Brake Kits, shocks and more.

ND Headlight Level Adjuster - help needed

Postby beardedstealth » Fri Jan 06, 2017 9:51 pm

Maybe my lobotomy was too invasive :shock: but I am stumped when it comes to this little adjuster. Is there any documentation on the install? Or can someone let me know at least where to look for the factory plastic link?

Thanks :lol:
beardedstealth
 
Posts: 16
Joined: Fri Feb 19, 2016 6:23 pm

Re: ND Headlight Level Adjuster - help needed

Postby Sean @ GWR » Mon Jan 09, 2017 3:41 pm

Hello! Installation is fairly simple but the OEM piece is hiding behind the driver's side rear wheel near the rear sway bar end link. The OEM headlight level link is highlighted in the photo below. The link is held in by two 10mm nuts.

IMG_3842.JPG


Install the GWR headlight level adjuster but do not tighten the jam nuts. To properly adjust the head lights you'll need to lower the car back on the ground.

IMG_3846.JPG


With the car on the ground you'll want to adjust the length until the arm is level with the pivot point. Once you've adjusted the link, tighten the jam nuts (indicated by the red arrows) and you are good to go. A couple notes on adjustment. If the arm is pointed UP you'll have your headlights aimed too low. If the arm is pointed DOWN, your headlights will be aimed too high and blind other drivers.

IMG_3849.JPG
Sean @ GWR
 
Posts: 57
Joined: Wed Oct 22, 2014 12:55 pm

Re: ND Headlight Level Adjuster - help needed

Postby beardedstealth » Sat Jan 14, 2017 7:48 pm

You guys are awesome. So glad I found Good-Win-Racing. Thank you
:D
beardedstealth
 
Posts: 16
Joined: Fri Feb 19, 2016 6:23 pm


Return to Installation Instructions

Who is online

Users browsing this forum: No registered users and 2 guests