Page 1 of 1

ND Headlight Level Adjuster - help needed

Posted: Fri Jan 06, 2017 9:51 pm
by beardedstealth
Maybe my lobotomy was too invasive :shock: but I am stumped when it comes to this little adjuster. Is there any documentation on the install? Or can someone let me know at least where to look for the factory plastic link?

Thanks :lol:

Re: ND Headlight Level Adjuster - help needed

Posted: Mon Jan 09, 2017 3:41 pm
by Sean @ GWR
Hello! Installation is fairly simple but the OEM piece is hiding behind the driver's side rear wheel near the rear sway bar end link. The OEM headlight level link is highlighted in the photo below. The link is held in by two 10mm nuts.
IMG_3842.JPG
Install the GWR headlight level adjuster but do not tighten the jam nuts. To properly adjust the head lights you'll need to lower the car back on the ground.
IMG_3846.JPG
With the car on the ground you'll want to adjust the length until the arm is level with the pivot point. Once you've adjusted the link, tighten the jam nuts (indicated by the red arrows) and you are good to go. A couple notes on adjustment. If the arm is pointed UP you'll have your headlights aimed too low. If the arm is pointed DOWN, your headlights will be aimed too high and blind other drivers.
IMG_3849.JPG

Re: ND Headlight Level Adjuster - help needed

Posted: Sat Jan 14, 2017 7:48 pm
by beardedstealth
You guys are awesome. So glad I found Good-Win-Racing. Thank you
:D

Re: ND Headlight Level Adjuster - help needed

Posted: Fri Feb 15, 2019 6:03 am
by KurtH460
I put a pinion angle guage on the "headlight level adjuster arm" and found that 2017 MX-5 Club at OEM ride height with OEM springs & Bilsteins, the arm has approximately a 10° downward angle.

Once I swap in springs, I'll report back how much that angle changes.