NC Spring Perch Installation

[skeeler]

Brian,

I'm interested in your delrin spring perches for the rear of the NC:

http://www.good-win-racing.com/Mazda-Pe ... -0197.html

Can you explain more what you mean by this?

INSTALL NOTES, you need about 3/8th spacer to get the shock more straight so it won't rub the Delrin adapter (and 5mm longer bolt). Depending on the coilover you may also need to look at the sleeve that slides into the bottom of the shock (on our Ohlins the provided sleeve is sufficient).

Where do the 3/8-inch space and longer bolt go? Also, a friend who did his own conversion a couple of years ago told me that the lower top hat lip surrounding the mount for the stock spring is tilted. He had the top hat machined flat in order to fit his adapter. Is that necessary with your adapter?

Thank you for your help.

[Brian]

We don't machine anything to use the adapter....we just put it in.

The spacer goes between bottom shock and it's connection to the car (and you need longer bolt as result). The stock shock is traveling in an arc, that's why the stock spring is high clearance 'bee hive' shape. Thus, to convert to standard spring you are moving out bottom connection so shock travels normal straight up and down.

[skeeler]

Brian,

Thanks for the prompt reply. Looking under my car, I understand what you mean. I have a few of follow-up questions, if you don't mind:

• You say the delrin adapter works with 65- and 70-mm springs. I assume it is machined to work with 65-mm springs, and there's 2.5 mm of slop on each side when used with 70-mm springs. Is that correct?
• On a related note, is your helper-spring adapter for the bottom designed the same way, to work with both 65-and 70-mm springs?
• Do you recall the diameter, pitch, and length of the required longer screw? Similarly, what ID and OD are required for the 3/8-inch spacer?

Thanks again.

[Brian]

I don't recall the spec on the bolt, just pull and match it up with longer version. Yes, Delrin part milled for 65mm but we usually use 70mm because you need less spacer that way. As the picture suggests, the spacer was designed for use up front with 65mm springs.

[skeeler]

OK, Brian. Thanks for your reply. You have the spring rate I'm interested in from Swift, so that would make for 1-stop shopping for me.