Mazda Talk Forums

Nope. Just checked - it's not on the Fighter.

Chris,

The photos on your Flickr stream are certainly helpful. Thanks. What type of material and what thickness did you use for your fabricated seatbelt-buckle mount?

Thanks again.

The straps were 2" wide, 14 gauge (about 2mm).

Chris,

Thanks for the information.

I noticed that the seat rails I ordered from Brian came with an extra small, loose plate. I assume, since there is just one, that it is somehow related to mounting the passenger-side seatbelt at the bottom, since, in stock form, that end of the belt attaches to the passenger seat. Is that correct, or is it intended for another purpose? Should I have received two of them?

Thanks again.

Huh...I don't remember getting one of those.

Sounds like something else got left in the box....the rails....are just the rails as pictured on the website. Perhaps you should email me a pic of this other plate in the box.

rpmchris wrote:Huh...I don't remember getting one of those.

Perhaps Mr Goodwin can fill us in.

Hey all,

I have the NC seat brackets from the site here and can't figure out how they're pre-drilled for the Sparco sliders -- I think I'm missing something. I have a Sparco Pro 2000 seat (so it has both the bottom and side mounting options), and when I bolt the sliders directly onto the seat, they don't come close to matching up to the seat bracket.

What is meant by the "pre-drilled for Sparco Sliders" feature-- the bottom hole locations on Sparco seats seems to be the same across the line of bottom-mounting seats, so I know that's not the problem. I also tried using the side mounts (and then attach the sliders to those) to see where the holes would line up, but they also seemed to be off by quite a bit.

What am I doing wrong and I apologize if I'm missing something obvious!

Richard

You bolt the sliders to the rail, and your seat to side mounts....

NA/NB seats on our rails.

Sparco Corsa