Fitting techna-fit stainless steel lines on NC
Posted: Wed May 11, 2011 9:20 am
Today i tried to fit my recently purchased stainless steel brake lines on my '06 NC.
As i put the right front end first, i noticed that the new brake lines are much longer than the OEM ones.It seems like on hard cornering they might come in contact with the wheel.There is a mount wich bolts onto the upper A-arm (as the oem do) with a nut but the tube is moving freely through it leaving lots of it(the tube) on the loose.
What should i do?
I am very concerned because on the event of a contact with the spinning wheel i might end up with no brakes!
I didn't took pictures because i was covered in brake fluid but i'm sure you understand the situation i'm describing above.
As i put the right front end first, i noticed that the new brake lines are much longer than the OEM ones.It seems like on hard cornering they might come in contact with the wheel.There is a mount wich bolts onto the upper A-arm (as the oem do) with a nut but the tube is moving freely through it leaving lots of it(the tube) on the loose.
What should i do?
I am very concerned because on the event of a contact with the spinning wheel i might end up with no brakes!
I didn't took pictures because i was covered in brake fluid but i'm sure you understand the situation i'm describing above.