Page 9 of 9

Re: NC track build

Posted: Sat Nov 28, 2015 8:35 am
by eflove
Those were a custom deal with machined balljoint studs and generic circle car links. I've been working with SPL testing these samples out before the production run that will be typical SPL quality/colors.

Re: NC track build

Posted: Sat Nov 28, 2015 8:28 pm
by eflove
All done. Time to take it to the track.
Image

Re: NC track build

Posted: Mon Nov 30, 2015 1:05 pm
by Ryan @ GWR
Same splitter hardware we use with the countersunk large washers :) What material did you use for your splitter?

Car looks great! Is this a CJ Wilson Racing project or a personal side-project?

Re: NC track build

Posted: Mon Nov 30, 2015 4:23 pm
by eflove
This is a personal project. I worked at CJWR for a number of years including when I started this build. Lots of nights and weekends. The splitter is made from a AL honeycomb core with fiberglass skins. It's used in airplanes as flooring I think. I was messing around today seeing how strong it is.....
Image

Re: NC track build

Posted: Wed Dec 09, 2015 2:17 pm
by eflove
To post a update after trying out the new bits. It all works quite well and has settled the car down quite a bit. It puts power down on exit so well now I never even turned the traction control on. I was surprised how much it made a difference in the slower corners. Took around 3sec off the lap times. It does had a push in the slower sections now so i'll be making changes to cure that.

Re: NC track build

Posted: Sun Jan 03, 2016 6:17 pm
by eflove
All the force pushing down on the rear created more squat than I was expecting. I need to make some adjustments to keep running at such a bumpy track.
Image
Image

So I installed shock travel sensors that i'll be using as a more basic purpose of measuring ride height and compression. I will be adding some rear ride height, putting the rear sway back on, and possibly playing with spring rate.
Image
Image
Image
Image
Image
Image

Re: NC track build

Posted: Thu Jun 16, 2016 12:06 pm
by LukeW879
eflove... I'm racing an NC w/NASA Texas, and wanting to do full aero, if you have a spare moment would you shoot me an email: wuckert135@gmail.com I'd greatly appreciate it!

Re: NC track build

Posted: Mon Feb 04, 2019 9:06 am
by Brian
Customer updated worn out 2.5 to built 2.3L 3576 .83 and custom cams, wow!

Image

2.3 DISI Block
2.5 Cylinder Head
Mountune Springs / Retainers
Custom CAMS
Aged 925 Head Studs
Sequential Race Trans
RX8 Rear diff and more
Garrett GTX3576 Gen2
Tial .83 AR

Re: NC track build

Posted: Sun Feb 17, 2019 10:32 am
by Brian
Fast At Super Lap