Mazda Talk Forums

My search skills are lacking, so if this is a repost, I apologize. I am installing the RB sways this weekend on the front and rear of my NC2. Will this combo decrease understeer when attached in the middle hole on the front and the hole nearest the end on the rear per the instructions? Or, since I know I want to reduce low speed understeer, should I go with the stiffer rear set up?

TIA
Jon D.

I suggest starting with middle hole front and hole nearest bar ends of rear. Drive and see what you think. Other variables effect the balance like alignment settings. If still too much understeer after first few drives then set rear bar to tighter position....or front bar to loose (connection nearest bar ends)....or both as needed.