93Le Miata Bump Stop Upgrade

Miata Parts, Intakes, Superchargers, Headers, Exhausts, Shocks, Springs, Sway Bars, Brake Kits, Autocross and track mods.

93Le Miata Bump Stop Upgrade

Postby SteveD765 » Fri Dec 22, 2017 12:07 pm

93 LE miata with the factory Bilsteins (125k miles) and Springs.

Ordered the 58mm Red/White AutoCross bumps. It's probably a dumb question, but would like to make sure I've got everything set before I start the install.

I'm guessing that I:
1) Pull the shock
2) put spring compressors on
3) remove the center bolt
4) Throw the dust boot (already in many pieces) / rubber bump into the trash
5) Bumps go on, the narrow end toward shock body
6) Put the center screw on
7) Install shocks.

Are there any spacers, fender washers, that should be going on top of the bumps, or am I good with just the bump stop on the shock shaft?
SteveD765
 
Posts: 3
Joined: Tue Oct 24, 2017 5:28 pm

Re: 93Le Miata Bump Stop Upgrade

Postby Brian » Sat Dec 23, 2017 11:25 am

No extra bits needed, you swap just the low density stock stops for these higher density versions.
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Brian
Site Admin
 
Posts: 8175
Joined: Tue Feb 15, 2005 11:44 am
Location: San Diego CA

Re: 93Le Miata Bump Stop Upgrade

Postby SteveD765 » Tue Dec 26, 2017 2:22 pm

Thanks for the Help!
SteveD765
 
Posts: 3
Joined: Tue Oct 24, 2017 5:28 pm


Return to Mazda Miata and Fiat 124

Who is online

Users browsing this forum: No registered users and 2 guests