MIATA ENGINE BUILT BY STEWART RACING ENGINES

Welcome to the Good-Win Racing Forum. Feel free to tell us who you are, leave any comments or suggestionson how we can serve you better
Post Reply
MagMan
Posts: 2
Joined: Sat Jul 31, 2010 3:35 am

MIATA ENGINE BUILT BY STEWART RACING ENGINES

Post by MagMan »

1999 Engine, built by Stewart Racing Engines; Baseline flow bench testing, Jet Clean Block, Zyglow block, surface block, hone with torque plate, align hone mains, pressure test block, bore block .40 over, race prep, final wash, measure bearing clearances, file fit rings, assemble short block, record all measurements, stretch rod bolts. Full competition head port and polish, weld/reshape and polish combustion chambers, cc chambers, 1mm larger intake and exhaust valves, deshroud valves, performance valve job, MazdaSpeed intake cam, Fidanza adjustable exhaust cam gear, Ferrea valve train kit, .40 over custom spec’ed 10:1 compression Weisco pistons, pin fit bushings, pin fit pistons, Carillo H beam rods, size rod big ends, balance rods and pistons, polish and balance crankshaft, ARP studs, OEM ported and polished intake manifold, port and polish connector and flange port match to Accufab polished 65mm throttle body and block intake, RC 550cc fuel injectors, M-Tuned fuel rail, final flow bench test, final engine balance with clutch/flywheel, Stewart Engines tricks of the trade.

Cost: $10,232.39
Price: $7,500.00 plus shipping or best offer
Attachments
Miata Engine.jpg
Miata Engine.jpg (241.82 KiB) Viewed 2951 times
Brian
Site Admin
Posts: 11307
Joined: Tue Feb 15, 2005 11:44 am
Location: San Diego CA
Contact:

Re: MIATA ENGINE BUILT BY STEWART RACING ENGINES

Post by Brian »

Gorgeous!

Lots of great info! A few points that potential buyers will want to know include: Reason for selling? Motor not run in yet, has been run in? Has been run half a season with 10 pounds of boost? How many hours on it? Built it for a particular class?
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
MagMan
Posts: 2
Joined: Sat Jul 31, 2010 3:35 am

Re: MIATA ENGINE BUILT BY STEWART RACING ENGINES

Post by MagMan »

Thanks Brian.

Motor not run in yet. Not built for an particular class, I just had it built to be a strong engine that could take a lot of boost. Jim Stewart recommended the .040 overbore to give him a little more room to work on the head and also recommended the 10:1 compression ratio for faster boost, the high quality internals can take it!
Post Reply