Page 1 of 1

Polly Urethane Bushings for MX-5's with OEM RX-8 sway-bars.

Posted: Tue Mar 25, 2014 10:38 am
by AZ Sun Lover
All SOLD!

I was able to pick-up some more plug & play polly bushings. I keep getting PM's about how to get these.
They are cheap but a PIA to get, so I worked at getting more. I use and love these little things! I think they really make a difference. If you have rubber bushings, you will really like these.

The price is $30.00 shipped for a set of (4) for 27mm front & 16mm rear. *27mm is for the Yellow & Orange front sway-bars.*

The price is $29.00 shipped for a set of (4) for 25mm front & 16mm rear. *25mm is for the Red front sway-bars.*

All OEM RX-8 rear sway-bars are 16mm.

I also have one set of (4) red used 25mm bushings. Asking $15.00 shipped for this one set.

My direct email is;

hayrandyl@cox.net

Thanks for looking.

Re: Polly Urethane Bushings for MX-5's with OEM RX-8 sway-ba

Posted: Wed Mar 26, 2014 6:04 am
by njaremka
I'd be in for a set to work with my yellow dot sways.

Question: The bushings do not appear to be split? Would the installation involve removing the end links and slipping the bushing over the end of the bar?

Re: Polly Urethane Bushings for MX-5's with OEM RX-8 sway-ba

Posted: Wed Mar 26, 2014 2:05 pm
by AZ Sun Lover
njaremka wrote:I'd be in for a set to work with my yellow dot sways.

Question: The bushings do not appear to be split? Would the installation involve removing the end links and slipping the bushing over the end of the bar?
The fronts "split" in the center, the rears "split" on the side. :?
On the rear, install so the "split" is at the bottom.
Just send me an email, Ok?

Thanks.