Cosworth Roller Barrel Throttle Bodies

Welcome to the Good-Win Racing Forum. Feel free to tell us who you are, leave any comments or suggestionson how we can serve you better

Cosworth Roller Barrel Throttle Bodies

Postby Brian » Tue Jun 19, 2018 1:32 pm

Cosworth Roller Barrel Throttle Bodies with two spare filters $999, which is HALF of new cost.

Held onto this thinking we would build another full out track NC, but with planning to move it is time to let it go. Need Motec or similar to run this setup, cable activated, not drive by wire with factory ECU. We ran this setup in our NCLIGHT, added a good 20hp over 70mm tb. Sound was AMAZING, throttle response equally AMAZING. Don't buy it unless you REALLY know what you are doing, you need to fab up the linkage and cable setup, custom ECU, etc. Dyno is what we made with stock block mazda3 2.5 with stock crank, high compression pistons, comptech cams.
NCLightC.jpg (26.91 KiB)
Cosworth25R.jpg (43.89 KiB)
Brian Goodwin
Good-Win Racing
Site Admin
Posts: 10391
Joined: Tue Feb 15, 2005 11:44 am
Location: San Diego CA

Re: Cosworth Roller Barrel Throttle Bodies

Postby DanielS172 » Tue Jun 19, 2018 3:53 pm

Is this CARB approved tho? Kidding :lol:
2014 Club | OEM hardtop | GWR HH mid, FM muffler | ZetaCRD | Wilwood LBBK | Blackbird Fabworx GT3 roll bar | TRMotorsports FF10s
Posts: 58
Joined: Mon Jul 25, 2016 7:09 pm

Return to Lounge, Track Day Notices, Specials, YOUR Classifieds etc

Who is online

Users browsing this forum: No registered users and 2 guests