Cosworth Roller Barrel Throttle Bodies with two spare filters $999, which is HALF of new cost.
Held onto this thinking we would build another full out track NC, but with planning to move it is time to let it go. Need Motec or similar to run this setup, cable activated, not drive by wire with factory ECU. We ran this setup in our NCLIGHT, added a good 20hp over 70mm tb. Sound was AMAZING, throttle response equally AMAZING. Don't buy it unless you REALLY know what you are doing, you need to fab up the linkage and cable setup, custom ECU, etc. Dyno is what we made with stock block mazda3 2.5 with stock crank, high compression pistons, comptech cams.
https://youtu.be/PB3BFoX1oII
Cosworth Roller Barrel Throttle Bodies
Cosworth Roller Barrel Throttle Bodies
- Attachments
-
- NCLightC.jpg (26.91 KiB) Viewed 4239 times
-
- Cosworth25R.jpg (43.89 KiB) Viewed 4241 times
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Good-Win Racing
www.good-win-racing.com
-
- Posts: 58
- Joined: Mon Jul 25, 2016 7:09 pm
Re: Cosworth Roller Barrel Throttle Bodies
Is this CARB approved tho? Kidding
2014 Club | OEM hardtop | GWR HH mid, FM muffler | ZetaCRD | Wilwood LBBK | Blackbird Fabworx GT3 roll bar | TRMotorsports FF10s