NC Wheel Fitment Question - 18x8"

Show off your lightweight high-performance wheels and see here what they look like on your Mazda before you buy.

NC Wheel Fitment Question - 18x8"

Postby bubbajan21 » Mon Nov 18, 2013 10:52 am

I'm looking at a set of 18x8 wheels with a 43 mm offset for my 2008 NC. I know most people on 8" wheels run closer to a 50 offset, so my question is what kind of fender rolling would be needed to fit these wheels and is it doable with the 43 offset?
Posts: 6
Joined: Mon Nov 18, 2013 9:56 am

Re: NC Wheel Fitment Question - 18x8"

Postby Brian » Tue Nov 19, 2013 6:31 am

If you did just 215mm wide tires and at least 1 degree negative camber you could fit that in factory fenders (no rolling needed). A 225mm tire would likely need a bit of roll. 235mm tire would need more roll, etc.
Brian Goodwin
Good-Win Racing
Site Admin
Posts: 10179
Joined: Tue Feb 15, 2005 11:44 am
Location: San Diego CA

Return to Wheel and Product Picture Gallery

Who is online

Users browsing this forum: No registered users and 3 guests