Show off your lightweight high-performance wheels and see here what they look like on your Mazda before you buy.
I'm looking at a set of 18x8 wheels with a 43 mm offset for my 2008 NC. I know most people on 8" wheels run closer to a 50 offset, so my question is what kind of fender rolling would be needed to fit these wheels and is it doable with the 43 offset?
- Posts: 6
- Joined: Mon Nov 18, 2013 9:56 am
If you did just 215mm wide tires and at least 1 degree negative camber you could fit that in factory fenders (no rolling needed). A 225mm tire would likely need a bit of roll. 235mm tire would need more roll, etc.
- Site Admin
- Posts: 9537
- Joined: Tue Feb 15, 2005 11:44 am
- Location: San Diego CA
Return to Wheel and Product Picture Gallery
Who is online
Users browsing this forum: No registered users and 3 guests