DonovanS079 wrote:So I’m curious about the helmholtz midpipe, you offer a 4 or 5 inch. I’m going to be doing a 2.5 swap soon but I have an automatic so I have to use the 4 inch midpipe, what are the draw backs of not using the 5 inch midpipe on the bigger engine?
KevinB238 wrote:Hi Brian. I did the 1.8 header and midpipe this weekend on my NC. When moving the studs from the downstream connection on the old header to the new header, I noticed that the side of the studs that goes into the header flange is not long enough to screw a nut on it. The stud is threaded into the header flange and then the spring is compressed on the midpipe flange, and that’s the only nut holding that connection in place. Is that correct? Or do I need to buy new studs so I can put a nut on the header side too?
Users browsing this forum: No registered users and 2 guests