Installations instructions for MonsterFlow intakes, Big Brake Kits, shocks and more.
I'm installing progress sways and RB end links -- wondering how important it is for the arms to be parallel to the ground. If it is important, I don't see how that's going to happen unless I'm doing something wrong. Picture below shows car on stands with only one end link connected.
Does everything here look correct?
- image.jpg (1.04 MiB)
- image.jpg (1.26 MiB)
2009 - Marble White
- Posts: 46
- Joined: Mon Jun 28, 2010 5:19 pm
- Location: DFW
The way the NC bar is designed, it just isn't going to happen. Just make sure there isn't any twist in the bar when the car is sitting on the ground.
- Posts: 79
- Joined: Fri Dec 17, 2010 10:31 am
Because the end links are ball joints, there won't be any bind up if you tighten them while the suspension is in full droop and then put the car back on the ground when finished. No problems, finish up and enjoy!
- Posts: 128
- Joined: Mon Nov 15, 2010 12:02 am
Return to Installation Instructions
Who is online
Users browsing this forum: No registered users and 3 guests