Hello,
I was wondering if the Sparco Pro200 will fit in the 2006 NC? Will the shoulder hit the door panel? Can I use it with the seat rails sold here?
Thanks
Sparco Pro2000
-
- Posts: 31
- Joined: Sun Apr 01, 2007 6:15 pm
Sparco Pro2000
2006 Mazda MX-5 Sport (Winning Blue Mica)
Class: CSP (Ohlins DFV-Revalved, Swift Springs, RX-8 Front Stabilizer Bar, RS Full Exhaust System, AWR Rollbar, Autopower 6-point Harness, Sniper Tuned)
Class: CSP (Ohlins DFV-Revalved, Swift Springs, RX-8 Front Stabilizer Bar, RS Full Exhaust System, AWR Rollbar, Autopower 6-point Harness, Sniper Tuned)
Re: Sparco Pro2000
I started by bolting a Sparco Pro 2000 into the NC LIGHT before switching to a Cobra Suzuka....
That's a stripped out NC but my guess is that the Sparco would still fit in a regular NC.
That's a stripped out NC but my guess is that the Sparco would still fit in a regular NC.
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Good-Win Racing
www.good-win-racing.com
Re: Sparco Pro2000
I've done some measurement recently ( i am also looking for seat upgrade). by pure calculation, anything over 23 inch on the shoulder area will most likely mount off center by a little. I love the Chrono Sport but too bad it doesn't support 5 pts harness sub-belt.