Maverick the Shop Truck!

Welcome to the Good-Win Racing Forum. Feel free to tell us who you are, leave any comments or suggestionson how we can serve you better
Brian
Site Admin
Posts: 10768
Joined: Tue Feb 15, 2005 11:44 am
Location: San Diego CA
Contact:

Re: Maverick the Shop Truck!

Post by Brian »

ReadyRamp on the Maverick.

Been impressed with the flexibility of the Maverick bed. Ford calls it 'Flexbed' and part of that is you can set the tailgate at different heights. Thanks to the unibody construction the modest 54 inch bed is flat and almost without wheel arches. Molded into the side of the bed are slots where you can use your own DIY dividers cut from standard bits of lumber. Also, lots of tie downs top and bottom in the bed.

Maverick's bed is wide enough to accommodate a 4x8 sheet of plywood. The tailgate can be locked at 45°, at which angle its height aligns with the aforementioned supports to keep your plywood flat. In this position, the tailgate can support up to 400 pounds. If you need length the load floor extends to 6’ with the tailgate fully extended.
Attachments
2022-Ford-Maverick-FLEXBED-Graphic1.jpg
2022-Ford-Maverick-FLEXBED-Graphic1.jpg (60.09 KiB) Viewed 1175 times
Ford-Maverick_2L-EcoBoost-AWD_Lariat_12.jpg
Ford-Maverick_2L-EcoBoost-AWD_Lariat_12.jpg (91.05 KiB) Viewed 1177 times
MavRR.jpg
MavRR.jpg (1.25 MiB) Viewed 1178 times
ReadyRampMav.jpg
ReadyRampMav.jpg (1.28 MiB) Viewed 1178 times
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Brian
Site Admin
Posts: 10768
Joined: Tue Feb 15, 2005 11:44 am
Location: San Diego CA
Contact:

Re: Maverick the Shop Truck!

Post by Brian »

More Small Truck Doing Truck Jobs!
Mav1.jpeg
Mav1.jpeg (615.64 KiB) Viewed 1126 times
Friends had their fridge stocked for the holiday and the compressor failed and all the appliance stores in town told them delivery would be at least a week. Little Maverick to the rescue. Continuing to use this little truck daily for most errands, it's just so easy with the really low bed height. Tow ratcheting straps to hold it and 20 miles down the freeway we went with zero issues. I used a gym mat and some old ramps to make my loading and unloading easier.
maverick lowering fridge.jpg
maverick lowering fridge.jpg (430.11 KiB) Viewed 1103 times
MavFridge3.jpg
MavFridge3.jpg (420.04 KiB) Viewed 1100 times
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Brian
Site Admin
Posts: 10768
Joined: Tue Feb 15, 2005 11:44 am
Location: San Diego CA
Contact:

Re: Maverick the Shop Truck!

Post by Brian »

Sunrise Surf with 7'6 board.
Attachments
SunriseMaverick.jpg
SunriseMaverick.jpg (965.04 KiB) Viewed 1093 times
SunriseMav2.jpg
SunriseMav2.jpg (946.64 KiB) Viewed 1093 times
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Brian
Site Admin
Posts: 10768
Joined: Tue Feb 15, 2005 11:44 am
Location: San Diego CA
Contact:

Re: Maverick the Shop Truck!

Post by Brian »

Still having fun with the Mav!
Attachments
MavAngleFun.jpg
MavAngleFun.jpg (2.15 MiB) Viewed 1001 times
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Brian
Site Admin
Posts: 10768
Joined: Tue Feb 15, 2005 11:44 am
Location: San Diego CA
Contact:

Re: Maverick the Shop Truck!

Post by Brian »

Fun review of the Lariat Trim we have.

https://www.businessinsider.com/ford-ma ... os-2022-10
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Ryan @ GWR
Posts: 439
Joined: Fri Oct 17, 2014 11:37 pm

Re: Maverick the Shop Truck!

Post by Ryan @ GWR »

Pro-LIFT kit springs announced by Eibach

Fitments in forums at https://www.mavericktruckclub.com/forum ... rick.7776/

Wheels in pics below are 17x8 at 40 offset. Tire size is 245/70R17.
Eibach_prolift_1.jpg
Eibach_prolift_1.jpg (853.92 KiB) Viewed 649 times
Eibach_prolift_2.jpg
Eibach_prolift_2.jpg (3.7 MiB) Viewed 649 times
Eibach_prolift_3.jpg
Eibach_prolift_3.jpg (3.26 MiB) Viewed 649 times
Ryan @ GWR
Posts: 439
Joined: Fri Oct 17, 2014 11:37 pm

Re: Maverick the Shop Truck!

Post by Ryan @ GWR »

H&R's Maverick on their new Super Sport lowering springs for AWD/FX4 models:
mav-24__large.jpg
mav-24__large.jpg (196.74 KiB) Viewed 492 times
mav-25__large.jpg
mav-25__large.jpg (200.41 KiB) Viewed 492 times
mav-41__large.jpg
mav-41__large.jpg (249 KiB) Viewed 492 times
Ryan @ GWR
Posts: 439
Joined: Fri Oct 17, 2014 11:37 pm

Re: Maverick the Shop Truck!

Post by Ryan @ GWR »

H&R Sport lowering springs:
c51620.jpg
c51620.jpg (248.14 KiB) Viewed 490 times
H&R Super Sport lowering springs:
c51620-77.jpg
c51620-77.jpg (586.1 KiB) Viewed 490 times
H&R Lift springs:
c51621.jpg
c51621.jpg (268.84 KiB) Viewed 490 times
Brian
Site Admin
Posts: 10768
Joined: Tue Feb 15, 2005 11:44 am
Location: San Diego CA
Contact:

Re: Maverick the Shop Truck!

Post by Brian »

Next up with our own Maverick is doing our own flavor of LIFT springs. Since we are in San Diego half the trucks here need to look like they are running the Baja 500 next weekend. Went over many variables including what the other companies like Eibach have done, and then worked with our friends at Progress on our own specs. Lots of folks are excited in the Maverick community about the 'Tremor' package from Ford that will have 235/65R-17 Falken WildPeak A/T Trail SL tires on 17x7 wheels in stock 37.5mm offset. We will be doing similar heights but a bit more aggressive size of the same tire, 245/65R-17 Falken WildPeak A/T Trail SL on 17x7.5 Sparco Dakar wheels in 35mm offset.
sparco_dakar_rbrz_full.jpg
sparco_dakar_rbrz_full.jpg (61.84 KiB) Viewed 302 times
Here is the factory Tremor Package:
Tremor.jpg
Tremor.jpg (178.66 KiB) Viewed 302 times
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Brian
Site Admin
Posts: 10768
Joined: Tue Feb 15, 2005 11:44 am
Location: San Diego CA
Contact:

Re: Maverick the Shop Truck!

Post by Brian »

OFF ROAD Wheels and Tires Ready
Attachments
TruckWheels.jpg
TruckWheels.jpg (1.03 MiB) Viewed 282 times
MaverickWheels.jpg
MaverickWheels.jpg (807.55 KiB) Viewed 282 times
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Post Reply