Hi Brian,
Is it possible to use Enkei NT03-M 17x9.5 ET44 on NC? The offset is close to RPF1 17x9's ET45 and offer .5" more width. Is back space an issue? seeing how 18x9.5 ET45 can fit with 285 tires, these should fit fine too right?. The fender will be rolled of course.
Thanks
NT03-M 17x9.5 ET44 on NC?
That rim will fit...I have always liked that rim and it would look really good on the NC. You may need to roll fenders...depending on tire size. Assuming a 235/40 you would need just a slight fender lip roll...depending on amount of lowering and amount of camber.
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Good-Win Racing
www.good-win-racing.com
I'm planning to run something like 255/40/17 tires such as the Z1 or XS.
I know rolling will be required for sure with tires that wide and offset that low. Will there be any unwanted rubbing with other suspension components?
My car is currently at ~13.25" fender to wheel center all around. Going to get alignment this weekend and planning to shoot for 1.8 degree of camber up front and 1.7 in the back
Thanks
I know rolling will be required for sure with tires that wide and offset that low. Will there be any unwanted rubbing with other suspension components?
My car is currently at ~13.25" fender to wheel center all around. Going to get alignment this weekend and planning to shoot for 1.8 degree of camber up front and 1.7 in the back
Thanks