Re: Good-Win Racing NC and ND Brace Kit Installations
Posted: Thu Dec 17, 2015 12:26 pm
With the ND Rear shock brace in place, the panel covering the fuel tank needs some trimming to fit. This panel is very thin and not difficult to cut:
Unmodified panel laying in its approx. location, but cannot bolt-down because it interferes with the brace:
Line drawn on the panel showing roughly what portion needs to be trimmed off. We adjusted this a bit more following this:
Rough cut done:
Trimmed a bit more after a test-fit, then cleaned the edge up and put some rubber trim over the edge and installed:
Unmodified panel laying in its approx. location, but cannot bolt-down because it interferes with the brace:
Line drawn on the panel showing roughly what portion needs to be trimmed off. We adjusted this a bit more following this:
Rough cut done:
Trimmed a bit more after a test-fit, then cleaned the edge up and put some rubber trim over the edge and installed: