Mazda Talk Forums

Thanks Brian, and that makes sense as I'm closely looking at the original photos of the kit on your site.

I was asking because I'm running into a brand new issue and wanted to be be prepared incase I had to replace the clutch.

With only 12K miles since the install and only 10K miles on the car, last night the clutch would not fully disengage with the pedal to the floor. No signs of a master leak, no signs of problems with the pedal assembly, and the assembly appears to be adjusted correctly.

Sounds hydraulic, so my bet is clutch/flywheel is okay and issue is elsewhere. If not hydraulic then perhaps sticking throw-out bearing...but usually that comes with loud noise.