Cosworth Roller Barrel Throttle Bodies

Welcome to the Good-Win Racing Forum. Feel free to tell us who you are, leave any comments or suggestionson how we can serve you better

Cosworth Roller Barrel Throttle Bodies

Postby Brian » Tue Jun 19, 2018 1:32 pm

Cosworth Roller Barrel Throttle Bodies with two spare filters $999, which is HALF of new cost.

Held onto this thinking we would build another full out track NC, but with planning to move it is time to let it go. Need Motec or similar to run this setup, cable activated, not drive by wire with factory ECU. We ran this setup in our NCLIGHT, added a good 20hp over 70mm tb. Sound was AMAZING, throttle response equally AMAZING. Don't buy it unless you REALLY know what you are doing, you need to fab up the linkage and cable setup, custom ECU, etc. Dyno is what we made with stock block mazda3 2.5 with stock crank, high compression pistons, comptech cams.

https://youtu.be/PB3BFoX1oII
Attachments
NCLightC.jpg
NCLightC.jpg (26.91 KiB)
CosworthComplete.jpg
Cosworth25R.jpg
Cosworth25R.jpg (43.89 KiB)
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Brian
Site Admin
 
Posts: 8243
Joined: Tue Feb 15, 2005 11:44 am
Location: San Diego CA

Re: Cosworth Roller Barrel Throttle Bodies

Postby DanielS172 » Tue Jun 19, 2018 3:53 pm

Is this CARB approved tho? Kidding :lol:
2006 MX-5, marble white with black OEM hardtop: Flyin' Miata Stage 2 suspension, Flyin' Miata exhaust, GWR Helmholtz mid-pipe, Hard Dog M3 roll bar, Hawk HP+ pads, stainless steel lines, GWR/Moroso aluminum coolant overflow tank, Voodoo shift knob.
DanielS172
 
Posts: 39
Joined: Mon Jul 25, 2016 7:09 pm


Return to Lounge, Track Day Notices, Specials, YOUR Classifieds etc

Who is online

Users browsing this forum: No registered users and 2 guests