Koni STRTS top center nut torque?

Installations instructions for MonsterFlow intakes, Big Brake Kits, shocks and more.

Koni STRTS top center nut torque?

Postby DavidT632 » Sat Sep 11, 2021 8:04 am

What is the correct torque for the top center nut on the Koni STRTs? I recently installed these with stock springs on my NC1 but think I may have not tightened them enough. I do have a good bit of thread showing at the top. Too tight?

I am trouble shooting an occasional clunk I hear in rear drivers side coming off of speed bumps (esp if turning left at the same time) I have replaced the end links in the rear already and rechecked the torque on other bolts.

Any advice is much appreciated!

David
DavidT632
 
Posts: 1
Joined: Mon Jun 28, 2021 3:46 pm

Return to Installation Instructions

Who is online

Users browsing this forum: No registered users and 2 guests