What is the correct torque for the top center nut on the Koni STRTs? I recently installed these with stock springs on my NC1 but think I may have not tightened them enough. I do have a good bit of thread showing at the top. Too tight?
I am trouble shooting an occasional clunk I hear in rear drivers side coming off of speed bumps (esp if turning left at the same time) I have replaced the end links in the rear already and rechecked the torque on other bolts.
Any advice is much appreciated!
Installations instructions for MonsterFlow intakes, Big Brake Kits, shocks and more.
1 post • Page 1 of 1