ND-2 Front bump stops for autox
-
- Posts: 2
- Joined: Wed Mar 28, 2018 6:10 pm
ND-2 Front bump stops for autox
What length is left of the stop after cutting it? And which end do you cut? Thanks very much. That's the only thing I have left to do for a CS car.
-
- Posts: 2
- Joined: Wed Mar 28, 2018 6:10 pm
Re: ND-2 Front bump stops for autox
I’m just trying something new. From what I’ve read, cutting the stops frees the front end up. I’d like to do it once. I’m just now understanding the feeling of the car after four years of autocrossing.
An old geezer trying to kick those young whipper snappers.
An old geezer trying to kick those young whipper snappers.
Re: ND-2 Front bump stops for autox
No wrong answers here, it's all personal taste in the balance. I do like to cut fronts a good inch and use HARD stops at rear that equal length of factory rear stops per the rules.
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Good-Win Racing
www.good-win-racing.com
Re: ND-2 Front bump stops for autox
For clarity, the stock stops are 37.5 mm; Brian, are you suggesting you or others find cutting the front bump stop to 25mm frees up the front-end push?
Re: ND-2 Front bump stops for autox
Picture of ND1 vs ND2 stops. ....both are FRONT.
At this point I am using only the part 'circled' here by red square.
At this point I am using only the part 'circled' here by red square.
- Attachments
-
- ND1vsND2cut.jpg (85.94 KiB) Viewed 4825 times
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Good-Win Racing
www.good-win-racing.com
Re: ND-2 Front bump stops for autox
I finally got my Koni fronts installed, and I took a photo of the stock OE bump stops, shown as 2.25''.
- Attachments
-
- IMG_2615.jpeg (3.08 MiB) Viewed 4594 times