Car height question
Posted: Fri Jan 13, 2023 7:02 am
Miata ND 2020 Club, Brembo, Bilstein w/ H&R,4000 miles: Before I replaced the springs on the car, I measured the height of the fenders (on the right side only Unfortunately!), giving me a reference of 26" (floor to top wheel well). When I removed the original shocks on the rear, I noticed the right side bottom shock was easy to dislocate from its position, dropping perhaps 1/4' of the hub , however, when I separated the rear left side, the bottom of the shock was really hard to move off the hub. I was able to pry it out, dropping the shock to about 3/4" , which would indicate the left side suspension setup is tighter and higher than the right side. I installed all four corner set of shocks with H&R springs, and remeasured each corner. About 25" front Left , right, and rear right, the rear left side gave me 24.5" after realignement. My wife even noticed the car was lower on the left side while she followed me to the dealer for alignment. Not sure I can explain the difference of height. I double check my spring installation, but since I had issue separating the original left shock , I suspect something is a miss with the linkage or bent or ??? is this normal setup for miata to be lopsided? I have installed numerous H&R springs on my various BMWs , even my wife VW Sportwagen, so I can eliminate mistakes on my part related to rebuilding the shocks. New to Miata world, not sure what to make of it. Any ideas?