RPF 1 17x9 @ 45et
Re: RPF 1 17x9 @ 45et
How much work will be necessary to run 9x17's with 235/40 tires. I'm quite low on coilovers.
How much work is involved to the fenders to get this combo working?
How much work is involved to the fenders to get this combo working?
Re: RPF 1 17x9 @ 45et
So a mild fender roll front and rear would be enough to drive 235's? No camber fiddling, liner cutting, steer angle limiting?
Re: RPF 1 17x9 @ 45et
Well, if you go zero camber that might be an issue.....nobody has tried that. Figure anywhere over a degree of camber and the roll should be very mild. Had some guys report no roll needed when they were lowered a lot with over two degrees of negative camber.
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Good-Win Racing
www.good-win-racing.com
Re: RPF 1 17x9 @ 45et
Sorry to ask Yet another fitment question, I was curious if very little to no roll was needed when using the RS3 tire in the 225-45-17 size on this wheel ?
Thanks
Thanks
07' MX5 w/ Koni Sports
Re: RPF 1 17x9 @ 45et
Yes, that should clear...294 SiLo wrote:Sorry to ask Yet another fitment question, I was curious if very little to no roll was needed when using the RS3 tire in the 225-45-17 size on this wheel ?
Thanks
Brian Goodwin
Good-Win Racing
www.good-win-racing.com
Good-Win Racing
www.good-win-racing.com